Publicité
Les langues disponibles
Les langues disponibles
No.
Malfunction
11
Delay in remote control�
After returning to the OMNI
12
Station, DEEBOT does not empty
its Dust Bin�
13
Auto-Empty unsuccessful�
The inner side of the Dust
14
Collection Cabin is dirty�
Dust leakage occurs while
15
DEEBOT is working�
16
Mopping Pad Plates will not rotate�
The robot does not respond to the
17
Station's instructions�
EN
26
Possible Cause
The Wi-Fi signal is poor, causing the video loading to
be slow�
The Auto-Empty function has not been turned on in the
ECOVACS HOME App�
Dust Bag is not installed in the Station�
Manually moving the robot back to the Station may not
trigger the Auto-Empty function�
In Do Not Disturb mode, DEEBOT will not empty the
dust after returning back to the OMNI Station�
If the above possible causes have been ruled out,
components of the Station may be abnormal�
The Station detects a decrease in empty efficiency�
The outlet of the Dust Bin is blocked by foreign objects� Remove the Dust Bin and clear the foreign objects on the outlet�
Fine particles pass through the Dust Bag and
accumulate on the inner side of the Dust Collection
Cabin�
The Dust Bag is broken�
The outlet of the Dust Bin is blocked by foreign objects� Remove the Dust Bin and clear the foreign objects on the outlet�
The Mopping Pad Plates are not correctly installed�
The Mopping Pad Plates are blocked by foreign
objects�
DEEBOT is not in the Station�
Solution
Use DEEBOT in areas with good Wi-Fi signal�
Turn on the Auto-Empty function in the ECOVACS HOME App�
Install the Dust Bag, and close the Dust Collection Cabin�
It is recommended to allow DEEBOT return to the OMNI Station on
its own� Please do not manually move it�
Turn off Do Not Disturb in the ECOVACS HOME App or manually
start dust-emptying�
Please contact customer service for assistance�
Replace the Dust Bag according to the
section and close the Dust Collection Cabin� If the Dust Bag is not
full when prompted by the App, you can put it back again�
Clean the inner side of the Dust Collection Cabin�
Check and replace the Dust Bag�
Please install the Mopping Pad Plates correctly� A sound of Click
indicates properly installation�
Clear the foreign objects�
Please make sure DEEBOT is in the Station�
[Regular Maintenance]
Publicité
