Publicité
download the app directly from the app
store.
2. Follow the app onboarding instructions.
3. Turn on the appliance.
4. Press
or swipe to the left to enter
menu. Select: Settings / Connections.
5. Press to turn on or off: Wi-Fi.
The appliance wireless module starts within
90 sec.
2.4 GHz WLAN : 2400 - 2483.5 MHz
Frequency
Bluetooth : 2400 - 2483.5 MHz
2.4 GHz WLAN : EIRP < 20 dBm
(100 mW)
Max Power
Bluetooth : EIRP < 20 dBm (100
mW)
Protocol
2.4 GHz WLAN : IEEE 802.11bgn
5.3 Software licences
The software in this product contains
components that are based on free and open
source software. AEG acknowledges the
contributions of the open software and
robotics communities to the development
project.
To access the source code of these free and
open source software components whose
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
aeg.opensoftwarerepository.com (folder
NIU6).
5.4 Initial preheating and cleaning
Preheat the empty appliance before the first
use and contact with food. The appliance can
emit unpleasant smell and smoke. Ventilate
the room during preheating.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Enter menu and select: Functions.
3. Set the function
temperature. Let the appliance operate
for 1 h.
. Set the maximum
4. Set the function
temperature. Let the appliance operate
for 15 min.
5. Turn off the appliance and wait until it is
cold.
6. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
7. Put the accessories and removable shelf
supports back to their initial position.
5.5 Setting: Water Hardness
When you connect the appliance to the mains
you have to set the water hardness level.
Use the test paper or contact your water
supplier to check the water hardness level.
1. Put the test paper into the tap water for
about 1 sec. Do not put the test paper
under running water.
2. Shake the test paper to remove any
remaining water.
3. After 1 min, check water hardness with
the table below.
4. Set the water hardness level: Settings /
Setup / Water Hardness.
The colours of the test paper continue to
change. Check the water hardness within 1
min after testing.
The table shows water hardness range with
the corresponding level of water
classification. Adjust the water hardness level
according to the table.
Water hardness level
1 - soft
2 - moderately hard
3 - hard
4 - very hard
. Set the maximum
Test paper
ENGLISH
9
Publicité
