Publicité
2.5.
AUDIO CODE SETUP
If your Sound Bar / Audio Device is not one of the brands listed
above, you can also set up the remote to control it by entering a
4 digit code. The codes are listed in the Audio Codelist section of
this manual, and are listed by brand and then popularity. Locate
the brand of your Sound Bar / Audio Device in this code list and
then the procedure is:
1.
2.
3.
Enter the first 4 digit code for your Sound Bar / Audio Device.
The LED should blink twice on the last digit.
4.
5.
If they work, your remote is set up. If not try again from step 1
using the next code in the list.
RESET VOLUME CONTROL
To reset the volume control to the original setting:
Hold down the SETUP and VOLUME DOWN
keys until the LED blinks twice.
Hold down the SETUP and VOLUME UP keys
until the LED blinks twice.
Now try the Volume Up, Down and Mute and
see if they control your Sound Bar or Audio
Device.
Hold down SETUP and VOLUME DOWN keys
until the LED blinks 4 times. Volume control is
now reset.
17
EN
Publicité
