Stihl FS 360 C Notice D'emploi page 28

English
Fitting the Full Harness
Fitting the full harness is described in
detail in the instruction sheet supplied.
The type and style of the harness
depend on the market.
FS 260
Putting on the harness
1
2
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
26
All manuals and user guides at all-guides.com
Attaching machine to harness
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the shaft.
Balance the machine – see
N
"Balancing the Machine".
Disconnecting machine from harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
FS 360
2 Putting on the harness
1
1
2
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated rail (3).
Find the right attachment point for
N
the cutting attachment you are
using – see "Balancing the
Machine".
1
2
3
FS 260 C, FS 360 C