Stihl FS 360 C Notice D'emploi page 18

English
9
10
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
A
1
2
11
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
16
All manuals and user guides at all-guides.com
7
2
Raise the grip of the wing screw (7)
N
to the upright position.
Turn the wing screw
N
counterclockwise as far as stop.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Adjust the handlebar (2) so that
N
distance A is no more than 15 cm.
Line up the handlebar at a right
N
angle to the drive tube.
Turn the wing screw clockwise as
N
far as stop.
Fold the grip of the wing screw down
N
so that it is flush.
FS 260: Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
12
13
12
Attach the throttle cable (12) to the
N
retainer (13).
FS 260 C, FS 360 C
13