Publicité
6 | Remote control
5. Install the ventilation pipe with 2
screws [
Photo
Turn the door handle of the bottom unit
1. Disassemble the door handle of the
bottom unit: Remove the plastic cover
of the door lock on the inner side of
the door, by sliding the cover towards
the inner side of the door and taking it
out [
Photo
2. Loosen the screws of the door handle
with a 5 mm Allen key [
3. Pull the door handle off, turn it 180
degrees and reattach the door handle
[
Photo
17].
4. Apply the plastic cover [
6
Remote control
With the Combi-Duo tower, you have the
option of connecting the two units to-
gether.
NOTICE
The remote control setting must be
carried out on the controlling unit
In order for the remote control function
to work, the following steps must be
set on the controlling unit.
The controlling unit and the unit to be
controlled must be defined in advance.
a
The units are connected with an Ether-
net cable.
a
Both units are switched on and ready
for use.
1. Press the button (Pos. 1) Setting
[
Figure
19].
2. Press the button (Pos. 2) Cooking sys-
tem [
Figure
3. Press the button (Pos. 1) Remote con-
trol [
Figure
80.51.378_iCombiPro-iCombiClassic_CD-U_IM_EU-west
11].
15].
Photo
16].
Photo
19].
20].
>
The remote control menu is open.
You can carry out the configura-
tion.
4. Click the button (Pos. 2) Unit name
[
Figure
>
Enter a unique unit name.
5. Click the button (Pos. 3) Unit colour
[
Figure
>
Select the unit colour.
6. Switch the remote control button to
(Pos. 4) ON [
7. Press the button (Pos. 5) IP address of
unit to be controlled remotely
[
Figure
18].
>
Enter the IP address of the iCombi
to be controlled remotely.
>>
The units are connected together.
Important: You can switch between the
units (Pos. 6) [
When the controlling unit accesses the
unit to be controlled, the display is framed
in the selected colour (see step 5). This
shows that settings are now being carried
out on another unit.
Network connection for Combi-Duo
configuration with active remote
control
For units with active remote control,
the LAN ports are occupied and the
WiFi connection is deactivated. To
connect the units to a network, an
external switch must be set up.
Please note that the switch enables the
remotely controlled units to
communicate with each other and with
the network, e.g. for
ConnectedCooking.
20].
20].
Figure
20].
20].
Figure
20].
NOTICE
English
15 / 100
Publicité
