Publicité
English
Fitting, removing high-
pressure hose
RE 109, RE 119
Connecting the high-pressure hose
2
Push the coupling (1) onto the
N
connector (2)
Disconnecting the high-pressure hose
Unlock the high-pressure hose by
N
pulling the clutch (1) and remove
from the connector (2)
RE 129 PLUS
The high-pressure hose is already
connected.
12
All manuals and user guides at all-guides.com
High-pressure hose and spray gun
Fitting
RE 109
3
1
RE 119
RE 129 PLUS
5
3
Push the connector (3) of the high-
N
pressure hose into the mount on the
spray gun (4) – until it engages
Removing
Actuate the safety catch (5) and pull
N
the connector (3) out of the mount
on the spray gun (4)
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"
Connect the high-pressure hose
N
extension between the high-
pressure hose and spray gun.
4
5
4
Connecting the water supply
Connecting the water hose
N
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other dirt particles from
entering the machine and to purge the
air from the water hose.
Diameter of water
hose:
1/2"
Length of water hose: min. 10 m (to
absorb pres-
sure surges)
max. 25 m
2
Push the coupling (1) on to the hose
N
connector (2)
Turn on water supply
N
To vent the system:
Actuate the spray gun (without
N
spray lance mounted) until a
uniform water jet emerges
RE 109, RE 119, RE 129 PLUS
1
Publicité
