Publicité
Connecting to a compressed air source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (6 .3 bar) must be fully
reached, and
–
make sure that the trigger is in the upper position .
►
Use only connection hoses with an internal diameter of at least
9 mm .
►
Use only filtered, lubricated and regulated compressed air .
♦
Screw the connector nipple
in delivery state) . Tighten the connection with a pair of pliers .
♦
Attach the tool to a compressor by connecting the connector
nipple
with the supply hose of the compressed air source .
CAUTION!
►
Ensure that the compressed air hose is firmly attached . A loose
hose can thrash about uncontrollably causing grave danger .
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance .
♦
The compressed air source must be equipped with a pressure
reducer so that you can regulate the air pressure .
PDRS 6.3 B2
into the air inlet
GB │ IE
(Pre-assembled
│
57
■
Publicité
