Publicité
Repeat steps 2 and 3 until all
digit settings and adjustments
are completed, then press the
Select button to end.
+ The date adjustment is
complete when the digits
stop blinking.
Press the DATE button to
2
oare
display the Date + Time
ñ
mode.
Repeat steps 2 and 3 until all
digit settings and adjustments
are completed, then press the
Select button to end.
* The time adjustment is
complete when the *:" in the
time display stops blinking,
Sorot (QO) Set
Q
blinks on the LCD panel (no Date
imprinting) when the battery is replaced, reset the
date and time
+ Press the Set button to advance the digit by one, or
hold for two seconds or more to advance the value
continuously.
+ The date cannot be set or adjusted in Date + Time
mode.
+ After removing the battery to replace it, do not touch
any of the switches on the camera. This allows the
date and time settings to be retained for
approximately five seconds.
Ba
Publicité
