Riello RX 360 S/PV Instructions Pour Installation, Utilisation Et Entretien page 22

5.6 Positioning probe - electrodes
Before installing the burner on the boiler, make
sure the probe and electrodes are positioned cor-
rectly as in Fig. 14.
WARNING
If necessary use nuts 1) (Fig. 15) in order to obtain
the correct positions.
Respect the dimensions shown in Fig. 14.
WARNING
The burner is supplied with combustion head and
electrodes assembled.
WARNING
5.7 Securing the burner to the boiler
For the installation proceed as follows:
 Assemble the air intake 1) with the screws 2) and nuts.
 Connect the high voltage cables to the transformer
23)(Fig. 16), and the ionisation probe lead to the appropriate
cable emerging from the control box.
 Fix the train assembly 20)(Fig. 16) using the 4 screws 18)
provided.
 Install the gas train following the instructions on pag. 23.
Be aware of the presence of the gasket
19)(Fig. 16) and the gas seal.
WARNING
20068189
Installation
20071129
20084009
23
D9777
20 GB
Electrodes
Probe
20
Fig. 14
Fig. 15
19
18
Fig. 16