Publicité
All manuals and user guides at all-guides.com
Charging process
Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in dry
areas.
Do not switch on the device
while charging it.
There is a risk of injury from
electric shock.
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
•
Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short
periods in succession.
•
Use the charger supplied to charge
the Li-ion battery installed in the
equipment.
•
Recharge the battery if the equipment
runs too slowly.
•
In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
•
Defects resulting from improper han-
dling are not subject to the guarantee.
1.
The safety key (7) must be du-
ring the loading process plug.
2. Connect the charger cable plug
(17) with the charger socket on
the tool (5).
3. Connect the power supply unit
(16) to a socket.
The charging indicator (6) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging time
is max. 3 – 5 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug from the tool.
Operation
Keep to noise abatement regula-
tions and other by-laws.
Switching on and off
1. Remove the blade guard (11/14)
before switching the unit on.
2. Insert the safety key (7) into the
device.
3. To switch on, hold the switch lock
(2) depressed and operate the
on/off switch (8). Then release
the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of
the on/off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come to a
complete standstill. Do not touch
the moving blades and do not try to
stop them moving. Injury hazard!
GB
77
Publicité
