Sherco 250 SE-R Manuel Du Propriétaire page 97

1
2
1
Pilot jet and pilot (air) screw:
In order to adjust the idle range A to B
transition you can change the pilot jet
(its size is stamped on it) and adjust the air
screw , turning the screw in richens
2
the mixture.
Proceed by turning the screw 1/8 of a turn
at a time, if you move out of the rage of
1T-2.5T, change the size of the pilot jet.
Needle :
The needle has 5 notches for adjustment, 1 to 5,
from rich to lean.
The reference number of the needle is engraved
on it. In the tables the adjusting position of the clip
on the needle is defined from the upper position.
N84K
N84K
POOR
N84J
N84W
N84H
N84G
N84F
N8RE
N8RD
N8RC
RICH
N8RB
Main jet :
The main jet is shown in the photo as
The size of the jet is engraved on it.
1
.
1
95