Replacing The Main Fuse; Replacing The Fuse For The Lights (250-300 Se/R); Removing The Headlight Housing - Sherco 250 SE-R Manuel Du Propriétaire

250-300 SE/R
Electrical system maintenance (continued)

REPLACING THE MAIN FUSE

REPLACING THE FUSE FOR THE LIGHTS (250-300 SE/R)

REMOVING THE HEADLIGHT HOUSING

1
2
128
1
1
Remove the seat (
☛
The main fuse is on a relay by the starter.
1
Remove the defective fuse and replace with
a new fuse of the same value.
Main fuse 30A
Put a new spare fuse in the reserve location
in the fuse box.
- Replace the saddle (
Remove the seat (
☛
The light fuse is located in a high location on
1
the wiring harness on the right side of the bike.
Remove the defective fuse and replace with
a new fuse of the same value.
Light fuse 15A
- Replace the saddle (
Turn the ignition to the off position.
Unclip the left and right rubber fastners
on each side of the fork.
Separate all of the brake hoses / cables from
the meter bracket at the top and bottom.
Move the top plate up to clear the housing.
Disconnect the connector
theheadlight housing.
p.108)
p.108).
☛
p.108)
p.108).
☛
1
and remove
2