Publicité
Fuse Hold
er and Voltage Changer Assembly
If a change in line voltage operation is desired, proceed as follows:
1.
2.
3.
4.
Figure 11
5.
MicroVac Controller User Manual / 87-900-089-01 (G)
Unplug the power cord from the controller rear panel socket.
On the power entry module (rear panel), check back door for
voltage selector set.
Using a small screwdriver, pull out the voltage selector and fuses
by levering in position A.
Replace the fuse.
Use only T-type fuses of the following characteristics:
100/120 Vac 1 A
220/240 Vac 1 A
Fuse holder and
voltage selector
Rear panel
Select the operating voltage, then firmly insert the voltage
selector and fuses in place.
Fuse Holder and Voltage Changer Assembly
Technical Information
A
5
57/72
Publicité
Chapitres
