Publicité
4
Instructions for Use
Installation
Each controller is factory set for a specific power supply:
Installation
WARNING!
The controller is equipped with a 3-wire power cord and plug
(internationally approved) for user's safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical shock.
High voltage developed in the controller can cause severe injury or death.
Before servicing the unit, disconnect the input power cable.
The controller must be installed inside a rack module, but it must be positioned
NOTE
so that free air can flow through the holes. Do not install or use the controller in
an environment exposed to atmospheric agents (rain, snow, ice), dust,
aggressive gases, or in explosive environments or those with a high fire risk.
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cable supplied
with the controller.
See the section "Technical Information" for detailed information
about the above mentioned and the other connections, and about the
options installation.
42/72
model 929-0201 KINGS type High voltage connector (220 Vac,
50/60 Hz)
model 929-0200 KINGS type High voltage connector (120 Vac,
50/60 Hz)
temperature: from 0 °C to +45 °C
relative humidity: 0 – 95 % (without condensation)
MicroVac Controller User Manual / 87-900-089-01 (G)
Publicité
Chapitres
