Fuse Holder Assembly - Agilent Technologies TwisTorr Medium Notice De Mode D'emploi

Fuse Holder Assembly

The following figure shows the location of this assembly.
Figure 6
Proceed as follows to replace one or both fuses:
1. Remove the fuse holders (position A) with a small screwdriver.
2. Replace the fuse.
3. Use only T-type fuses of the following characteristics:
TwisTorr Medium-TMP Rack Controller User Manual / 87-901-049-01 (B)
Rear panel
- 250 Vac 10 A (5x20 mm) High breaking capacity
Technical Information

Fuse Holder Assembly

A
17
A
213/284