Dreame H12 Pro Manuel D'utilisation page 9

Care & Maintenance
EN
Tips:
• Turn off the appliance before maintenance. Do not touch the power switch.
• Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
• If the vacuum is not used for an extended period, fully charge it, unplug the power plug,
and store the vacuum in a cool, low-humidity environment away from direct sunlight. To
avoid over-discharge of the battery, charge the vacuum at least once every 3 months.
Cleaning the Used Water Tank and the Filter
1. Press the Used Water Tank release
button, and pull the Used Water Tank
outwards to remove it.
2
1
3. Rinse the Used Water Tank and the tank
cover with clean water. Clean the tank by
the provided cleaning brush.
Note:
• If the filter is dirty, rinse it with clean water and dry it completely before use.
• Replacing the filter every 3 to 6 months is recommended.
11 11
2. Take out the filter from the Used Water
Tank cover. Remove the tank cover and
empty the tank.
Filter
Used Water
Tank Cover
4. Re-install the filter and the Used Water
Tank cover. Then re-install the Used Water
Tank until you hear a click.
Click
2
1
Care & Maintenance
Cleaning the Tube and the Dirt Sensor
Remove the Used Water Tank, gently wipe the tube
and the dirt sensor with a wet cloth before use.
Note: Do not rinse the tube or the dirt sensor.
Cleaning the Brush Assembly
1. First, press the brush roller cover release
buttons inwards on both sides to remove
the brush roller cover. Press the brush
roller release button, and the brush roller
handle will pop out. Pull it to take out the
brush roller.
1
2
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
Note:
• Clean as needed. Alternating use of the two provided brush rollers is recommended.
• Replacing the brush roller every 3 to 6 months is recommended.
Dirt Sensor
2. Clear the hair and debris tangled
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water. Air dry the brush roller
thoroughly, or dry it by activating the
drying mode several times.
4. Re-install the brush roller and the
brush roller cover until you hear a click.
EN
12 12