Dreame H12 Pro Manuel D'utilisation page 8
Masquer les pouces
Voir aussi pour H12 Pro:
- Manuel de l'utilisateur (21 pages) ,
- Manuel d'utilisation (60 pages)
Publicité
How to Use
EN
Start Cleaning
Gently step on the brush cover and recline the appliance backwards. Press the power
switch
to start operating. Press the
- the suction mode according to your needs.
＜140°
Note:
• Do not clean any foamy liquids.
• The appliance will be suspended in the upright position while running.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• Do not recline the appliance backwards more than 140° to prevent the appliance from leaking
water.
• When the appliance is in operation, do not lift it off the ground or lay it flat. Doing so may cause
the used water to flow into the motor.
Cleaning the Used Water Tank
Press the Used Water Tank release button to take out the tank. Remove the tank cover
and pour out the used water. Close the tank cover and re-install the tank before use.
2
1
9
9
to switch among the auto mode - the ultra mode
3
4
How to Use
One-Press Self-Cleaning
1. Place the appliance back onto the base while you finish cleaning. Ensure that the water
in the Clean Water Tank is sufficient for self-cleaning.
2. Briefly press the self-cleaning button on the top of the handle, the self-cleaning
indicator will light up, and the appliance will start self-cleaning.
3. Please empty the Used Water Tank after self-cleaning is completed and drying mode has
been engaged. Press the button
to exit the drying mode.
Note: The self-cleaning function can be enabled only when the appliance is being charged and the
battery level is more than 15%.
Drying Mode
1. Press and hold self-cleaning button
seconds to activate drying mode.
2. The appliance will be charged once drying is
completed.
minimum water level of self-cleaning
Minimum Water Level of Self-Cleaning
Note:
• After self-cleaning is complete, promptly clean the Used Water Tank. Clean the charging base if
there are any stains left on the base.
• If cleaning the brush roller manually, please air-dry it thoroughly or dry it by using drying mode
several times to ensure a good drying effect.
for 3
EN
10
10
Publicité
