Dreame H12 Pro Manuel D'utilisation page 7

Charging
EN
1. Place the charging base against a wall on level ground and connect it to a
power source. Fully charge the appliance before first use.
2. Place the appliance on the charging base. When the voice prompt "Charging Started"
is displayed, the appliance activates the charging mode. When charging, the number
on the display screen represents the current battery level as a percentage. When the
number reaches 100, the battery is fully charged.
Note:
• If there is no operation within 10 minutes of being fully charged, the appliance will enter sleep mode.
Please restart the appliance if you need to use it.
• To extend the battery life time, the battery keeps cooling down for about one hour automatically
after you have used the appliance for a long time.
7 7
How to Use
Working Modes
The appliance will start in auto mode by default. You can switch to the suction mode or
the Ultra Mode based on your needs.
Auto Mode
While cleaning the floor, the appliance will automatically adjust its suction
power according to different situations.
Ultra Mode
Preparing Ultra Mode, please wait for 30 seconds.
This mode is suitable for deep cleaning.
Suction Mode
If the suction mode is selected, the appliance will vacuum water only and the
brush roller will not be dampened. No water is coming out of the Clean Water
Tank.
Filling the Clean Water Tank
Press the Clean Water Tank release button and pull the tank outwards to remove it.
Remove the cover of the Clean Water Tank and fill the tank with clean water. Install the
Clean Water Tank and ensure it clicks into place.
Cleaning Fluid
For better cleaning performance, it is recommended to add 10ml/0.34 oz detergent with
the bottle cap into the full Clean Water Tank, then shake gently and evenly for use.
Do not add any liquids other than the officially-approved cleaner. The cleaner can be
available on the official online store.
WARNING: To reduce the risk of fire and electric shock due to internal component damage,
use only dreame cleaning fluid intended for use with the appliance.
EN
8 8