Publicité
EN
Preparation
Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
If filling the tank from a water line, ensure that the line or a hose does not project
into the tank.
1. Pull up the red button on the safety valve [12] until all excess pressure is released from
the tank. (Fig. 5).
2. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 6).
3. Unscrew the pump [2] from the tank [1]. (Fig. 7).
+
We recommend you mix the spraying liquid in the device or premix it in an external tank:
Fill to 1/3 with water, pour in the spraying agent, and then add more water until full.
4. Add the spraying liquid to the tank [1] (Fig. 8).
5. Screw the pump [2] into the tank [1]. (Fig. 9).
6. Press the pump handle [13] down and turn it clockwise.
► The pump handle is unlocked. (Fig. 10).
7. Generate the required pressure (→ Table 2) in the tank [1] (Fig. 11).
+
The maximum pressure should not exceed 6 bar (88 psi)(red line on the pressure
gauge [16], Fig. 11). If the maximum pressure is exceeded, the safety valve will engage
and release the excess pressure
8. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 6).
16
ENGLISH
Publicité
