Publicité
Failure removal
Failures
Engine does not start
Engine growling, running but not
starting
Equipment starting but getting
blocked under small load and
switching automatically o
The contact pressure o the hand
wheel is too loose
Drum not rotating ater starting the
machine
Causes
No power supply.
Broken cable
Gear ring blocked
Deective condenser
The extension cable is too long or
with a small cross section
The socket is too ar rom the main
line and the extension cable has a
small cross section
The pressure spring is not sufciently
tight
Deective V-belt or mismatching
voltage
Removal
Check the voltage. Technical data
given on the type label must corre-
spond with electric network voltage.
Any checks or replacements to be
provided by a proessional electrician
Switch the machine o, unplug it
and clean it or replace the ring gear
components.
Deliver the machine to the customer
service centre or repair
Extension cable to be at least 1.5
mm2 or a length o up to 25 m
Cross section o at least 2.5 mm2 or
longer cables
Tighten the screw on the pressure
spring
V-belt replacement
ENGLISH
33
Publicité
