Publicité
c) If the speed is too slow, the product turns left.
Increase the speed to cut straight.
8. Put your hands on the handlebar when you have the
correct cutting speed.
9. Pull the front pointer lever to lift the front pointer,
when you get near a wall. Use the kerf guide to
make sure that you cut straight.
CAUTION
objects hit the blade block. It can cause
damage to the product.
To stop the product
1. Pull the forward speed lever to "STOP".
16
Make sure that no
2. Push the rear part of the cutting depth switch to lift
the blade.
3. Push down the throttle control fully.
4. Turn the ignition key to "OFF".
794 - 001 - 19.04.2022
Publicité
