Publicité
To connect a dust extractor to the
product
1. Turn the wing nut on the plug counterclockwise.
2. Remove the plug from the pipe on the blade block
cover.
3. Connect a dust extractor to the blade block. Turn the
screw to attach it.
Note
If the dust extractor is not compatible with the
connection on the product, use an adapter.
To operate the product
1. Start the engine. Refer to
page 12 .
2. Push the front pointer lever to "DOWN". The front
pointer is fully lowered.
14
To start the engine on
3. Align the front pointer (A) and the kerf guide (B) with
the line where you will cut.
B
4. Pull the throttle control up fully.
Note
Always operate the engine at full engine
speed for maximum capacity.
5. Push on the front part of the cutting depth switch to
lower the blade.
A
794 - 001 - 19.04.2022
Publicité
