Publicité
been developed to permit the joint sawing very soon
after floor finishing, sometimes within 0 to 2 hours...if the
cut is sawn within a few hours after the final finishing,
random cracking can be controlled..."
Husqvarna has the only Ultra Early Entry dry-cutting
system (Soff-Cut) which controls random cracking
through the early timing of the cut. With the Soff-Cut
method, control joints are usually cut within 2 hours after
the finishing process.
Joint cutting should begin as soon as the concrete will
support the weight of the saw and the operator at each
joint location and before final set.
If the joints are not being cut within this time frame
then the Soff-Cut Ultra Early Entry method is not being
followed.
Before you operate the product
1. Do daily maintenance. Refer to
17 .
2. Make sure that the front guide is turned to the
forward position.
3. Fill the oil tank. Refer to
for information about recommended engine oil.
4. Do a check of the oil level. Refer to
engine oil level on page 21 .
To fill fuel
WARNING
you are in a vehicle. Risk of fire. Put the
container on the ground away from your
vehicle.
CAUTION
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION
not use unleaded gasoline with more than
10% ethanol. Gasoline with more than 10%
ethanol cause a risk of fire and can also
cause starting and performance problems.
It can also cause damage to metal, rubber,
and plastic parts of the fuel system.
CAUTION
contains methanol.
CAUTION
30 days in a container. Expired fuel can
cause damage to the product.
12
Introduction on page
Technical data on page 31
To examine the
Do not fill containers when
Do not use gasoline with an
Use unleaded gasoline. Do
Do not use gasoline that
Do not keep fuel more than
1. Remove the product from the transportation vehicle
and put it on the ground. If this is not possible, refuel
the product with a portable container and not from a
gasoline pump nozzle.
WARNING
gasoline containers.
2. Open the fuel tank cap slowly to release the
pressure.
3. Make sure that the nozzle touches the top edge of
the fuel tank opening until the fuel tank is full. Do not
use a nozzle lock-open device.
4. Clean the area around the fuel tank cap.
5. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
6. Move the product a minimum of 3 m/10 ft from the
position where you filled the tank before a start.
To start the engine
CAUTION
can be started with the forward drive
engaged. Make sure the forward speed
lever is in "STOP" position before the engine
is started.
1. Pull the forward speed lever to "STOP".
2. Make sure that the cutting height position is up.
Use only approved
The engine on this product
794 - 001 - 19.04.2022
Publicité
