Publicité
•
Cancer
•
Birth defects
•
Skin inflammation
•
Use correct equipment to decrease the quantity of
dust and fumes in the air and to decrease dust on
work equipment, surfaces, clothing and body parts.
Examples of controls are dust collection systems
and water sprays to bind dust. Decrease dust at
the source where possible. Make sure that the
equipment is correctly installed and used and that
regular maintenance is done.
•
Use approved respiratory protection. Make sure
that the respiratory protection is applicable for the
dangerous materials in the work area.
•
Make sure that the airflow is sufficient in the work
area.
•
If it is possible, point the exhaust of the product
where it cannot cause dust to go into the air.
Noise safety
WARNING
instructions that follow before you use the
product.
•
High noise levels and long-term exposure to noise
can cause noise-induced hearing loss.
•
To keep the noise level to a minimum, do
maintenance on and operate the product as given
in the operator's manual.
•
Examine the muffler for damages and defects. Make
sure that the muffler is correctly attached to the
product.
•
Use approved hearing protection while you operate
the product.
•
Listen for warning signals and voices when you use
hearing protection. Remove the hearing protection
when the product is stopped, unless hearing
protection is necessary for the noise level in the work
area.
To remove the product from the
package
•
Lift the product from the center handle on the safety
frame to remove the product from the package.
Introduction
WARNING
product, you must read and understand the
safety chapter.
10
Read the warning
Assembly
Before you assemble the
Safety instructions for maintenance
WARNING
instructions that follow before you use the
product.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Stop the engine and let the product become cool
before you do the maintenance.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Disconnect the spark plug cap before you do the
maintenance.
•
The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
•
Do not change the product. Modifications that
are not approved by the manufacturer, can cause
serious injury or death.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
Replace damaged, worn or broken parts.
•
Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
•
Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
•
Let an approved service center do servicing on the
product regularly.
WARNING
cable from the spark plug before you
assemble the product.
To assemble the cutting blade and the
skid plate
1. Assemble the cutting blade. Refer to
cutting blade on page 20 .
2. Assemble the skid plate. Refer to
skid plate on page 21 .
Read the warning
Remove the spark plug
To install a
To assemble the
794 - 001 - 19.04.2022
Publicité
