Horizon Fitness 7.4AT Manuel Du Propriétaire page 7

ASSEMBLY STEP 3
HARDWARE FOR STEP 3
PART TYPE DESCRIPTION
F ARC WASHER 8.4X15.5X1.6T
G SHORT BOLT M8x1.25Px15L
H LONG BOLT M8x1.25Px70L
6
2
F
7
G
H
4
12
A Open HARDWARE FOR STEP 3.
QTY
B Have someone help hold the console while attaching
the CONSOLE CABLE (2). Use the lead wire to
4
carefully pull the CONSOLE CABLE (2) out of the
2
RIGHT CONSOLE MAST (4). Attach the CONSOLE
2
CABLE (2) from the CONSOLE (6) to the CONSOLE
CABLE (2) from the top of the RIGHT UPRIGHT MAST
(4). Detach and discard the lead wire.
C Carefully slide the CONSOLE (6) onto the
ATTACHMENT BRACKETS (7) being careful not to
pinch the CONSOLE CABLE (2). Align the holes on the
bottom side of the CONSOLE (6) with the holes on the
ATTACHMENT BRACKETS (7).
D Attach the CONSOLE (6) to the ATTACHMENT
BRACKETS (7) by first placing ARC WASHERS (F)
onto BOLTS (G) AND (H) as illustrated. Insert SHORT
BOLTS (G) into the top hole of the ATTACHMENT
7
BRACKET (7) and LONG BOLTS (H) into the bottom
hole.
Repeat STEP D for the opposite side.
E
4
F G
ASSEMBLY STEP 4
HARDWARE FOR STEP 4
PART TYPE
I BOLT
J SPRING WASHER
K FLAT WASHER
6
9L
H
A Open HARDWARE FOR STEP 4.
DESCRIPTION QTY
B Attach RIGHT SIDE PULSE RATE GRIP (8)
to the underside of the CONSOLE (6) using
M8 15L 8
x
4 BOLTS (I), 4 SPRING WASHERS (J) and
8.2X15.4X2.0T 8
4 FLAT WASHERS (K).
8.4X15.5X1.6T 8
C Connect the RIGHT CONSOLE CABLES (9R)
and carefully tuck in wires to avoid damage.
D Repeat STEP B on the LEFT SIDE.
E Connect the LEFT CONSOLE CABLES (9L)
9R
and carefully tuck wires to avoid damage.
NOTE: Fully tighten all bolts from PREVIOUS STEPS
8
I
K
J
I
ASSEMBLY COMPLETE!
Before the first use, lubricate the treadmill deck by
following the instructions in the MAINTENANCE
section in the TREADMILL GUIDE.
J K
13