Horizon Fitness 7.4AT Manuel Du Propriétaire page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY STEP 1
HARDWARE FOR STEP 1
PART
TYPE
DESCRIPTION
A
UPRIGHT GUIDE BOLT
M8X1.25PX11L
B
MAST BOLT
M8X1.25PX80L
8.4X15.5X1.6T
C
FLAT WASHER
D
SPRING WASHER
8.2X15.4X2.0T
7
2
4
A
1
A
3
C
D
B
10
A
Cut the yellow banding straps and lift the running
deck upward from the rear to remove all contents from
QTY
underneath the running deck.
2
B
Open HARDWARE FOR STEP 1.
8
C
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
8
BRACKET (1) and fully tighten.
8
NOTE: Do not fully tighten the following bolts until the
end of STEP 4.
D
Pull the CONSOLE CABLE (2) away from the treadmill
base frame. Connect the CONSOLE CABLE (2) from
the MAIN FRAME (3) to the CONSOLE CABLE (2)
in the bottom of the RIGHT CONSOLE MAST (4).
The other end of the CONSOLE CABLE (2) should be
4
located at the top of the mast.
E
Attach RIGHT CONSOLE MAST (4) to MAIN
FRAME (3) using 4 BOLTS (B), 4 FLAT WASHERS (C)
B
AND 4 SPRING WASHERS (D). Feed the extra console
D
C
cable back into the upright mast.
NOTE: Be careful not to pinch the console cable
while attaching the right console mast.
F
Repeat STEP E on the LEFT SIDE.
A
C
B
D
ASSEMBLY STEP 2
HARDWARE FOR STEP 2
PART
TYPE
DESCRIPTION
E
BOLT
M6X1.0PX15L
E
5
4
4
QTY
4
NOTE: Do not fully tighten bolts until STEP
3.
Open HARDWARE FOR STEP 2.
A
B
Attach CROSS SUPPORT BAR (5) using holes on
UPRIGHT MASTS (4) with 4 BOLTS (E).
E
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7.4 at treadmill

Table des Matières