Publicité
FR
ES
8. Before turning on the saw, perform a dry run of the cutting operation to check that there are no
problems such as a clamp interfering with the cutting action.
PT
9. Hold the handle (14) and firmly and squeeze the switch trigger (15). Allow the blade to reach
maximum speed and slowly lower the blade into and through the workpiece.
IT
10. Release the switch trigger (15) and allow the saw blade to stop rotating before raising the
blade out of the workpiece. Wait until the blade stops before removing the workpiece.
EL
19. LASER
1. You can switch the laser ON and OFF with the switch (25)
PL
2. The laser (5) directs a beam onto the workpiece
3. Extremely precise cuts can be made using the laser function.
UA
11. MAINTENANCE
RO
WARNING! RISK OF INJURY! Always switch the appliance off and
EN
out any work on the appliance.
1. When all the adjustments, settings or maintenance have been done, make sure that all keys and
wrenches have been removed and that all screws,bolts and other fittings are securely tightened.
2. Keep the tool's air vents unclogged and clean at all times. Occasionally you may seesparks
through the ventilation slots. This is normal and will not damage your power tool.
3. Regularly check to see if any dust or foreign matter has entered the grills near the motor and
around the trigger switch. Use a soft brush toremove any accumulated dust.
4. Wear safety glasses to protect your eyes whilst cleaning.
5. If the body of the saw needs cleaning, wipe it with a soft damp cloth. A mild detergent can be
used but nothing like alcohol, petrol or other cleaning agent.
6. Never use caustic agents to clean plastic parts.
CAUTION: Water must never come into contact with the saw.
7. Store the tool, instruction manual and accessories in a secure place. In this way you will always
have all the information and parts on hand.
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
GENERAL INSPECTION
1. Regularly check that all the fixing screws are tight. They may vibrate loose over time. Check
especially the outer flange. lf there is vibration, screws can loosen with time.
220
220
unplug
before carrying
Publicité
