Publicité
FR
2. TECHNICAL SPECIFICATIONS
ES
Miter saw model: J1G-ZP18-210-3
Supply power . . . . . . . . . . . . . . . . . . . 220-240V~, 50Hz
PT
Motor capacity . . . . . . . . . . . . . . . . . . 1500W
No-load speed . . . . . . . . . . . . . . . . . . 4500/min
IT
Blade size . . . . . . . . . . . . . . . . . . . . . . ф210 xф30mm x 36T x 2.6mm
Use only a saw blade diameter in accordance with the markings on the saw and information about the
EL
bore diameter and the maximum kerf width of the saw blade.
Net weight . . . . . . . . . . . . . . . . . . . . . . . . . . 6.82kg
L
sound pressure level. . . . . . . . . . . . . . . 101.6dB(A)
PL
PA
K
uncertainty. . . . . . . . . . . . . . . . . . . . . . . 3 dB(A)
PA
L
sound power level . . . . . . . . . . . . . . . . 114.64dB(A)
UA
WA
K
uncertainty . . . . . . . . . . . . . . . . . . . . . . 3 dB(A)
WA
Laser Class . . . . . . . . . . . . . . . . . . . . . . . . . . .Class 2
RO
Laser Output Power (Max) . . . . . . . . . . . . . . ≤1mW
Wave Length (nm) . . . . . . . . . . . . . . . . . . . . .650
EN
CUTTING CAPACITY
• Miter table angles : 0° to 45° to the left & right
• Straight cut at 0° x 0° : 120 x 60 mm
• Compound miter cut at 45° x 45° :80x 33mm
• Bevel cut at 0° x 45° : 120 x 33mm
• Miter cut at 45° x 0° :80 x 60 mm
NOISE INFORMATION
The noise emission and its uncertainty measured in accordance with EN 62841-1.
- that the declared noise emission value(s) have been measured in accordance with a standard test
method and may be used for comparing one tool with another.
- that the declared noise emission value(s) may also be used in a preliminary assessment of exposure.
Wear hearing protection!
WARNING:
- the noise emissions during actual use of the power tool can differ from the declared values depending
on the ways in which the tool is used especially what kind of workpiece is processed; and
- the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
204
204
Publicité
