Publicité
User manual
TESTING A VEHICLE BATTERY
Enter the [Car] menu
Select the location of the battery.
In the vehicle: means that the battery is connected to the vehicle.
Outside the vehicle: means that the battery is no longer connected to the vehicle.
Motorcycle
Car
Waveform
Alternator Test
Start-up test
Review
Upload
- Battery test
- Start-up test
- Alternator test
If the test is performed on a battery in a vehicle (choose In Vehicle), the tester may detect a surface charge
and request that the lights be turned on to remove this surface charge from the battery.
The tester detects when the charge has been removed, and prompts to turn off the lights. Press
nue the test.
•
Select the type of battery from the following:
- Regular battery,
- AGM flat plate
- AGM spiral
- GEL
- EFB.
•
Standards and ratings
The battery tester tests each battery according to the relevant standard and nominal value.
Measurement
standard
measurement
CCA
BCI
CA
MCA
JIS
26A17-245H2
DIN
IEC
FR
SAE
22
Translation of the original
instructions
6 / 12 V vehicle battery test
Battery selection
6V battery
12V battery
Setup
In the vehicle
Range of
Cold Cranking Amps, the most frequently used value for
10-2000 A
starter batteries at 0°F (-18°C).
10-2000 A
International standard from the Battery Council.
10-2000 A
Cranking Amps standard, effective value of the starting current at 0°C.
10-2000 A
Marine Cranking Amps standard, effective value of the starting current at 0°C.
Japan Industrial Standard, displayed on the battery as a combination of numbers and
letters, for example 55D23, 80D26.
10-1400 A
Standard of the German Automotive Industry Committee.
10-1400 A
Standard from the International Electrotechnical Commission.
10-2000 A
Standard from the European Automobile Industry Association.
10-2000 A
Standard from the Society of Automotive Engineers.
Battery Location
In-Vehicle
Out-Of-Vehicle
Outside the vehicle
- Battery test
DBT 710 / PBT 720
In-Vehicle
Battery Test
Start-up test
Alternator Test
to conti-
Publicité
