Publicité
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction and follow the instructions
contained strictly. Additionally, the general safety
instructions of the leaflet supplied with the tool must be
observed. Prior to the first use, the user should absolve
a practical training. Save all warnings and instructions
for future reference.
If the mains cable gets damaged or cut during use, do
not touch it, but instantly pull the plug out of the socket.
Never use the tool with a damaged mains cable.
When drilling in ceilings or walls make sure you will not
cut through electrical mains, gas or water pipes. Use
metal detection systems if needed. Prior to the start of
your work, consult a statics specialist to determine the
exact drilling position. If drilling through ceilings, secure
the place below, because the core may fall downward.
Pay attention that the tool is not exposed to direct rain.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill in asbestos-containing materials.
Never carry the tool at its cable and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Insert the
plug into the socket only when the tool switch is off.
Modifications of the tool are prohibited.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the cable or plug.
Power tools have to be inspected visually by a specialist in regular
intervals.
During work, always lead the mains cable, extension cable and
extraction hose to the back away from the machine.
The machine should only work under supervision of sbd. Plug and
switch the machine off if it is not under supervision, e.g. in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
When the bit is jammed, stop applying downward pressure and turn off
the tool. Investigate and take corrective actions to eliminate the cause
of the bit jamming.
22
Publicité
