Publicité
5. Make sure black detergent nozzle is installed.
NOTE: Detergent cannot be applied with the high pressure
ProjectPro
®
nozzle (Orange, Yellow or Red) or optional turbo
nozzle.
6. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7. Start engine following instructions How to Start Your
Pressure Washer.
8. Rotate detergent shut-off valve on cleaning tank to "On"
position.
"On" Position
CAUTION
Mixing detergents can result in bodily injury and/or
property damage.
• DO NOT open both detergent shut-off valves at the same time.
9. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
10. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
16
Pressure Washer Rinsing
For Rinsing:
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
• Firmly grasp spray gun with both hands when using high
"Off" Position
Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engages to cool the pump by discharging
the warm water onto the ground.
1. Make sure both detergent shut-off valves are in the
"Off" position.
2. Remove black detergent nozzle from nozzle extension.
3. Select and install desired high pressure nozzle following
instructions How to Use ProjectPro
4. Keep the spray gun a safe distance from the area you
plan to spray.
WARNING
Kickback from spray gun can cause you to fall.
a ladder, scaffolding, or any other similar location.
pressure spray to avoid injury when spray gun kicks back.
5. Apply a high pressure spray to a small area, then check
the surface for damage. If no damage is found, it is
okay to continue cleaning.
6. Start at the top of the area to be rinsed, working down
with same overlapping strokes as you used for washing
and applying detergent.
®
Nozzle System.
BRIGGSandSTRATTON.COM
Publicité
