Publicité
9. Move throttle control lever (A) to "High" position,
shown on engine as a rabbit
10. Move choke lever to "Choke"
NOTE: For a warm engine, be sure the choke lever is in the
"Run"
position.
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
11. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
12. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
.
A
• NEVER pull starter cord without first relieving spray gun
• When starting engine, pull cord slowly until resistance is felt and
position.
• After each starting attempt, where engine fails to run, always
• Firmly grasp spray gun with both hands when using high
• DO NOT allow CHILDREN to operate pressure washer.
• Keep high pressure hose connected to pump and spray gun
• NEVER aim spray gun at people, animals, or plants.
• DO NOT secure spray gun in open position.
• DO NOT leave spray gun unattended while machine is running.
• NEVER use a spray gun which does not have a trigger lock or
• Always be certain spray gun, nozzles and accessories are
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
pressure.
then pull rapidly to avoid kickback.
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
pressure spray to avoid injury when spray gun kicks back.
13. When engine starts, slowly move choke lever to "Run"
position, as engine warms. If engine falters, move choke
lever to "Choke"
position, then to "Run"
14. After each starting attempt, where engine fails to run,
always point gun in safe direction, press red button and
squeeze spray gun trigger to release high pressure.
Move choke lever to "Choke"
steps 11 through 13.
15. If engine fails to start after six pulls, move choke lever
to "Run"
position, and repeat steps 11 through 13.
16. Point spray gun in a safe direction, push the red button
to release the trigger lock, and pull the trigger.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
while system is pressurized.
trigger guard in place and in working order.
correctly attached.
position.
position, and repeat
13
Publicité
