Publicité
WARNING
Contact with muffler area can result in serious
burns.
Exhaust heat/ gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (1.5 m) of clearance on all sides of pressure
washer including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
How to Stop Your Pressure Washer
1. Release spray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW
position (A).
A
3. ALWAYS point gun in a safe direction, press red button
and squeeze spray gun trigger to release retained high
water pressure.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
14
position, then STOP
How to Use ProjectPro
®
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro
ProjectPro
nozzles can be changed while pressure washer
®
is running once spray gun trigger lock is engaged. The
ProjectPro
nozzles vary the pressure and spray pattern as
®
shown.
Low Pressure
High Pressure
Delicate
General
40° Yellow
15° Orange
2550 PSI
2800 PSI
2.5 GPM
2.5 GPM
Follow these instructions to change ProjectPro
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange nozzles without the trigger lock on the spray
gun being engaged.
• DO NOT twist nozzles while spraying.
1. Pull back collar on quick–connect and pull current
ProjectPro
nozzles off. Store ProjectPro
®
holder provided on the accessory tray.
Nozzle System
system nozzles.
®
Black
Use to apply
detergent
Max
0° Red
2900 PSI
2.3 GPM
®
nozzles:
nozzles in
®
BRIGGSandSTRATTON.COM
Publicité
