Publicité
LED
Battery status
LED 1 is lit.
The battery power is low.
LED 1 flashes.
The battery is empty. The bat-
tery status indicator flashes.
Charge the battery. Refer to
charge the battery on page 16 .
To connect the battery to the product
WARNING:
products of the POWER FOR ALL system
18V.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide into the holder easily,
if not, it is not installed correctly.
(Fig. 41)
3. The battery locks into position when you hear a click.
To start the product
1. Push and hold the on/off button until the green LED
comes on. (Fig. 42)
2. Push the power trigger lockout and the power
trigger. The cutting equipment starts to rotate.
To adjust the loop handle and
telescopic shaft
1. Press the loop handle adjustment button.
(Fig. 43)
2. Adjust the loop handle to a suitable angle.
3. Release the loop handle adjustment button.
4. Loosen the lever on the shaft. (Fig. 44)
5. Set the necessary length on the shaft.
6. Close the lever and tighten the screw.
Note:
The two loop handle positions in the
following illustration are only for transportation and/or
storage.
(Fig. 45)
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The product shuts
down after 3 minutes.
1885 - 005 - 18.12.2023
To
Only use the battery with
To operate the product
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line
into the grass. (Fig. 46)
2. Decrease the length of the trimmer line by 8–10 cm/
3.15–4 in.
To clear grass
1. Keep the trimmer head above the ground.
2. Tilt the trimmer head.
3. Cut with the end of the trimmer line around objects in
the work area.
CAUTION:
that are hit by the trimmer line, increases
the wear on the trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass. (Fig. 47)
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. (Fig. 48)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
To stop the product
1. Release the power trigger and the power trigger
lockout.
2. Push the on/off button until the green LED goes off.
3. Push the release button on the battery and remove
the battery from the product. (Fig. 49)
To replace trimmer line
Refer to the last page of this operator's manual.
Cut grass. Other objects
Clean the trimmer head
17
Publicité
