Publicité
plug. The severed plug must be disposed of to
avoid a possible shock hazard and should never be
inserted into a mains socket elsewhere.
WARNING:
product makes an electromagnetic field
while it operates. This field may under some
conditions interfere with active or passive
medical implants. To decrease the risk of
conditions that can possibly injure or kill, we
recommend persons with medical implants
to speak with their physician and the medical
implant manufacturer before you operate the
product.
WARNING:
parts can be easily swallowed. There is
also a risk that the polybag can suffocate
toddlers. Keep toddlers away when you
assemble the product.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To attach the trimmer guard
1. Put the trimmer guard against the motor housing.
(Fig. 32)
2. Install the 2 bolts through the motor housing and the
trimmer guard. (Fig. 33)
3. Tighten the bolts.
To assemble the trimmer head
1. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
2. Install the combination tool in the hole to lock the
shaft.
3. Turn the trimmer head clockwise. (Fig. 34)
To install the plant guard
1. Install the plant guard into the holes on the motor
housing. (Fig. 35)
1885 - 005 - 18.12.2023
Cardiac arrest! This
Risk of suffocation! Small
Read the warning
Assembly
Read and understand the
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Only use original spare parts.
2. Make sure that the plant guard can move forward
and rearward freely. (Fig. 36)
To install the hook on the wall
•
Install the hook indoors.
•
Keep the hook out of sunlight and in ambient
temperature of -10°C to 70°C.
•
Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
•
Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary. (Fig. 37)
CAUTION:
screws are applicable for your wall type.
•
Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
Make sure that the wall
Make sure that the
15
Publicité
