Publicité
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
•
Do a general inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
•
Make sure that all nuts and screws are tight.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Ambient temperature
Operation of the bat-
-5 °C — 40 °C
tery in the product
Charging of the bat-
0 °C — 35 °C
tery
To charge the battery
Charge the battery before the first use.
Note:
The battery does not charge if the battery
temperature is more than +35 °C.
1. Connect the power cord for the battery charger in a
grounded mains.
16
Operation
Read and understand the
Before you use the battery,
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 38)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Battery status LED on the battery
charger
The red LED (A) and the green LED (B) on battery
charger show the battery status. Refer to
LED on the product on page 16 .
(Fig. 39)
LED
The green LED flashes
quickly.
The green LED flashes
slowly.
The green LED is on.
The red LED is on.
The red LED flashes
quickly.
Battery status LED on the product
When the battery is installed in the product, the LEDs on
the product show the battery status.
(Fig. 40)
LED
Battery status
LED 1, 2 and 3 are
Fully charged.
lit.
LED 1 and 2 are lit.
Sufficiently charged
Make sure that the
Do not pull the power
Battery status
Battery status
The battery is charging.
The battery is 80% charg-
ed.
The battery is fully charg-
ed.
Battery status
Refer to
LED on the product on
page 16 .
Battery status
Refer to
LED on the product on
page 16 .
1885 - 005 - 18.12.2023
Publicité
