Festo DGEA-18 Notice D'utilisation page 33

DGEA-...
Preparing the DGEA-...
1. Place the DGEA-... in the required mount-
ing position.
2. DGEA types with additional head:
Please note that stroke length H of the
DGEA-... depends on the distance "h"
between the two heads.
3. Tighten the fastening screws to the same
extent.
Fastening the work load:
4. Select the fastening situation for the work
load as per Fig. 10.
Fastening situation
On the pre-manufactured
cover
On the processed/
self-made cover
Fig. 10
Safety aspects of the design require that the profile tubing of the DGEA-... is
never operated without the cover (sharp edges, accident prevention
measures).
Please note
If the original cover is opened, the technical specifications in the chapter
"Technical specifications – interface-related" will lose their validity.
These do not apply until the factory status is restored.
This requires the screws to be tightened with the tightening torques specified
in the chapter "Technical specifications".
Festo DGEA-... 0106NH English
Fig. 9
Measures to be taken
Screw directly into the threaded holes
Make the cover with hole pattern and connector
pattern and then fit into place
H
h
33