Publicité
CONTINUOUS DRAINING
― ―
To connect the drain hose to the unit:
1.
Insert one end of the hose into the continuous drainage hole of the unit. Ensure it is
connected securely.
2.
Place the other end of the hose into a bucket or a drain.
3.
Ensure the hose is not bent or blocked.
Note: Gravity will pull the water out of the unit into your chosen drainage area. Ensure the chosen
area is not higher than the unit.
MAINTENANCE
― ―
Removing the water tank:
•
When the water tank is full, the unit will make a buzzing sound, and the Water Full light will
turn on.
•
Press the power button to turn off the unit.
•
Slide the water tank out of the body of the dehumidifier.
•
Empty the water tank and clean the inside and the outside.
•
Replace the empty tank back into the unit.
•
Press the power button to resume operating.
•
If the Water Full light does not turn off, check that the water tank is correctly in place.
WI-FI AND SMART LIFE SET-UP
― ―
Smart Life is a centralised app for smart device management. Control your unit from the Smart
Life app, set up schedules to turn your unit on and off and set up voice control.
Note: Ensure your Wi-Fi network is set to 2.4GHz for successful pairing.
Pair Your Device in 4 Steps:
1.
Register: download the Smart Life app on the Google Play or Apple app store. Sign in/
register for an account.
2.
Prepare your device: Once you're all signed in hold down the timer button for 3 seconds, to
turn on the unit's Wi-Fi pairing mode.
3.
Add your device: once the unit is in Wi-Fi pairing mode, open the Smart Life app press "+" in
the top right corner and press "add device".
4.
Pair your device: Then the app will scan for devices and then your unit (if it is in pairing
mode) will show up as shown below. Press add. Then type in the password for the Wi-Fi your
phone is on. Now your unit is connected to the Smart Life app.
Within the app, you can set your unit's mode, target humidity, fan speed and set an on/off
English | 13 of 122
Publicité
