Publicité
Laying the anchoring plate
Set up a foundation frame that is larger than the anchoring plate.
Insert the foundation frame into the dug hole.
If the above-ground track is used (001CAR-2), the foundation frame must protrude 50 mm above ground level.
Fit an iron cage in the foundation frame to reinforce the concrete.
Assemble the anchoring braces to the plate.
Fit the anchoring plate in the iron cage.
The pipes must pass through the hole.
Cast cement into the foundation frame.
The plate must be perfectly level and the screw threads completely above surface.
Wait at least 24 hours for the cement to dry.
Remove the foundation frame.
Fill the hole with soil around the concrete block.
Remove the nuts from the screws.
Insert the electrical cables into the tubes until they protrude by about 600 mm.
24h
Publicité
