Publicité
4. Plug Temperature Probe into Probe Jack on side of Slow Cooker. Press ON/
OFF Button to turn on. PROBE Light will illuminate. Default setting is HOT
Smoke with HOT Light flashing.
5. To change setting, press
6. After 3 seconds, default temperature of 160°F (70°C) will start flashing. Press
or
to adjust to desired temperature from 100°F to 200°F (38°C to
93°C).
7. Smoker will begin to heat after 3 seconds and Display will toggle between
actual and set probe temperature, with SET Light illuminated.
8. Unit will automatically beep 3 times and switch to WARM when desired
temperature is reached. KEEP WARM Light will illuminate and Display will
show warm time.
NOTES:
•
If Temperature Probe is unplugged during heating, PROBE Light will flash and
PrbE will flash in Display until Temperature Probe is plugged back into Probe
Jack. Probe must be replaced within 5 minutes. If Probe is left unplugged for
longer than 5 minutes, Smoker will go into standby mode.
•
It is normal for smoke to escape during cooking. Do not plug the Probe Hole
or press the Lid down while cooking.
•
During COMBO Smoke, COLD Smoke time is 1/3 of total time for Program
mode. For example, if COMBO Smoke is set for 6 hours, the first 2 hours
will be COLD Smoke and remaining 4 hours will be HOT Smoke. For Probe
Mode, COLD Smoke time is always 1 hour, and then unit will switch to HOT
Smoke until desired temperature is reached.
•
Smoking Chamber will darken after first use. Smoking Chamber must be
cleaned after every use.
SC87
or
to select COMBO Smoke.
9
Publicité
