Télécharger Imprimer la page

Beurer BM 25 Mode D'emploi page 25

Publicité

different categories (e.g. systolic pressure in the "high normal"
range and diastolic pressure in the "normal" range), the risk in-
dicator always indicates the higher range – "high normal" in the
example described.
Note that these default values are for general guidance
only, as individual blood pressures may vary.
Please note that self-measurement at home usually results in val-
ues lower than those recorded at a doctor's surgery. Consult your
doctor at regular intervals. Only they are able to give you personal
target values for controlled blood pressure, particularly if you are
receiving medical therapy.
Low blood pressure
 WARNING
Low blood pressure (hypotension) can be a health hazard and
cause dizziness or fainting. Blood pressure is considered low if
systolic and diastolic pressure are below 90/60 mmHg (source:
National Health Service, 2023).
Seek medical attention if you suddenly suffer from low blood
pressure.
7. CLEANING AND MAINTENANCE
• Clean the device and cuff carefully using only a slightly damp
cloth.
• Do not use any cleaning solutions or solvents.
• Under no circumstances hold the device or cuff under water, as
this can cause liquid to enter and damage the device and cuff.
• If you store the device and cuff, do not place heavy objects on
the device and cuff. The cuff line should not be bent sharply.
• Remove the batteries if the device is not going to be used for
a long period of time.
8. ACCESSORIES AND/OR
REPLACEMENT PARTS
Accessories and/or replacement parts are available at
www.beurer.de, under "Service". Please state the corresponding
order number.
Designation
Universal cuff (22-42 cm)
Mains part (EU)
Mains part (UK)
9. TROUBLESHOOTING
Error
Possible cause
message
Unable to record
a pulse.
The measured
blood pressure
is outside the
measurement
range.
There is a pneu-
matic system
error.
An error occurred
during the meas-
urement.
25
Item number and/or
order number
110.031
072.78
072.79
Solution
Please wait one minute and re-
peat the measurement. Ensure
that you do not speak or move
during the measurement.
Repeat the measurement.
Ensure that the cuff line is cor-
rectly connected and that you
do not move or speak.
Please wait one minute and re-
peat the measurement. Ensure
that you do not speak or move
during the measurement.

Publicité

loading