Publicité
• The use of accessories and/or replacement parts other than
those specified or provided by the manufacturer of this device
could lead to an increase in electromagnetic emissions or a
decrease in the device's electromagnetic immunity; this can
result in faulty operation.
• Keep portable RF communication devices (including peripheral
equipment, such as antenna cables or external antennas) at
least 30 cm away from all device parts, including all cables
included in delivery.
• Failure to comply with the above can impair the performance
of the device.
5. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
Cuff
1
Cuff connector
3
Risk indicator
5
START/STOP button
7
Information on the display
Low battery indicator
8
Diastolic pressure
10
Cardiac arrhythmia
12
symbol
/ Pulse
symbol
Cuff line
2
Connection for cuff con-
4
nector (left-hand side)
Connection for mains
6
adapter
Systolic pressure
9
Calculated pulse value
11
13
Cuff position control
Risk indicator
14
6. USAGE
6.1 Initial use
Inserting the batteries
• Remove the battery compartment cover on the back of the
device
.
A
• Insert the batteries (see chapter "Technical specifications").
Insert the batteries, making sure the polarity is correct accord-
ing to the label
.
A
• Close the battery compartment cover.
If the
symbol is displayed and does not disappear, meas-
urement is no longer possible. Replace all the batteries.
Operation with the mains part
You can also operate this device with a mains part (not included in
delivery). However, before connecting the device with the mains
part, please ensure that you have removed the batteries from the
device. During mains operation, there must not be any batteries in
the battery compartment, as this could damage the device.
• To avoid any potential damage, the device may only be oper-
ated with a mains part that meets the specifications described
in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
• Insert the mains adapter into the connection provided for this
purpose on the blood pressure monitor.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains part
from the mains socket first and then disconnect it from the
blood pressure monitor.
22
Publicité
