Publicité
Instruction manual
SUPERBRAVO 1 / 2
3.3 Electrical connection
The electronics are ready to support a 12V tension.
The Superbravo rail must be connected to the vehicle's electrical system with
an electrical cable of at least 4 mm
+ or - poles). The purpose of this connection is for the Superbrava stretcher to
charge the batteries when it is inside the ambulance.
It is recommended that this cable be protected on the outside with a plastic sheath to avoid
electrical problems (chafing, short circuits, etc.).
The electrical system has to be secured by means of a 20A fuse. (Built-in behind the
central rear cover).
34
cross-section (pay special attention to the
2
It must be ensured that the
is as indicated in the figure, otherwise the
stretcher will not be loaded into the vehicle.
positive pole
REV 2
10-24
Publicité
