Publicité
Instruction manual
SUPERBRAVO 1 / 2
2.2. Mounting the Superbrava (TG-2022) stretcher on the Superbravo rail
Thereafter, the stretcher shall be raised to the maximum level.
Check the loading manoeuvre and readjust if necessary.
On uneven terrain or changes in gradient, the stretcher can be raised to its maximum range
by pressing the right red and yellow button at the same time.
To load the stretcher onto the Superbravo rail, it must be in the outer position of the
ambulance. Pull the red lever to release the block and remove it. Once outside, the stretcher
is directed towards the ambulance's protruding profiles and the small wheels of the stretcher
are aligned with the rail.
28
The maximum range of the stretcher should only be adjusted the
first time the stretcher is loaded onto the rail. If moving to another
ambulance of a different height, it will have to be readjusted.
To set the maximum height of the stretcher's upward trajectory, the
stretcher should be positioned in front of the deployed rail on the
outside of the ambulance. Position the front wheels half a centimetre
above the profile where the small load wheels slide. (see side picture).
The stretcher must be kept in
1
this position when removed
from the rail.
Then look for the adjustment
cam on the top of the
2
stretcher near the shock
absorber attachment on the
headrest.
Rotate the cam until the end-
3
of-range light comes on.
Once in position, tighten the
screw 8 Nm to fix the cam in
4
its final position.
REV 2
10-24
Publicité
