Publicité
• Do not use the saw for insertion cutting
(grooves ending in the workpiece).
• The tool shall not be used for slotting,
rebating and grooving.
• Never use guards for handling or trans-
portation.
• Use and correct adjustment of the riving
knife, the max. distance between the saw
blade tip and riving knife shall not exceed
5mm.
• Use and correct adjustment of the riving
knife.
• Use a pusher rod or a pusher block to
move the tool past the saw blade.
• The push-stick or push block should
always be stored with the machine when
not in use.
• Put the pusher rod or pusher block into its
holder when not in use.
• Wear gloves when touching the saw
blades and rough materials. We recom-
mend that you keep saw blades in a pro-
tective bag whenever possible.
• When working outdoors non-slip footwear
is recommended.
• Wear protective hair covering to contain
long hair.
• Follow the lubrication and tool change
instructions.
• Check the connecting cable of the electri-
cal tool regularly and have it replaced by
a qualified specialist if it is damaged.
• Check extension cords periodically and
replace them if they are damaged.
• The floor around the machine must be
level, clean and free from loose particles,
such as chips and cuttings, be.
• The operator must be properly trained in
the application, adjustment and operation
of the machine.
• Make sure to use only spacers and spin-
dle rings that are suitable for the purpose
specified by the manufacturer.
• Make sure that the machine, if possible, is
attached to a bench or a table.
• No cuttings or other parts workpiece from
the cutting area removed while the
machine is running and the saw unit is not
yet at rest.
• Remember that moving parts may also be
located behind ventilation and venting
slots.
• Symbols appearing on your product may
not be removed or covered. Information
notices on the product that are no longer
legible must be replaced immediately.
Read instructions for use before use.
Dust extraction
Dusts from materials such as lead-containing
paint, some types of wood, minerals and
metal may be harmful to health. Touching of
inhaling the dusts can cause allergic reac-
tions and/or ailments of the respiratory tract of
the user or persons in the vicinity. Certain
dusts such as oak or beech dust are consid-
ered carcinogenic, particularly in combination
with wood treatment additives (chromate,
wood preservatives). Materials containing
asbestos may only be processed by experts.
– Always use a dust extraction facility.
– Make sure the workplace is well venti-
lated.
– Always wear a dust protection mask.
– Observe the regulations valid in your
country for the materials to be processed.
Risks caused by vibrations
CAUTION! Risk of injury due to
vibrations! Vibrations may, in par-
ticular for persons with circulation
problems, cause damage to blood
vessels and/or nerves.
If you notice any of the following
symptoms, stop working immediately
and consult a doctor. Numbness of
body parts, loss of sense of feeling,
itching, pins and needles, pain,
changes in skin colour.
The vibration values specified in the technical
data represent the main uses of the device.
The actual existing vibrations during use may
deviate from these as a result of the following
factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by fol-
lowing the tips below:
– Maintain the device in accordance with
the instructions in the operating instruc-
tions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and
your hands, in particular, are kept warm.
GB
63
Publicité
