Large Parent Unit; Getting Your Baby Monitor Ready - Philips NZ-SCD450/79 Mode D'emploi

Getting your baby monitor ready

EN
8
2 Insert four 1,5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries).
3 Close the battery compartment cover (A-10), using a coin
The baby unit is now ready for battery operated use.

Large parent unit

The large parent unit can be mains or battery operated.When
batteries are installed, you have an automatic back up in case of
mains failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — — < < + + - B-6) of the parent unit.
2 Connect the AC power adapter (B-4) to a wall outlet.
The large parent unit is now ready for mains
operated use.
Battery operated use
1 Open the parent unit's battery compartment, using a
screwdriver and slide down the cover (B-11).
2 Insert four 1,5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries).
3 Slide the battery compartment cover (B-11) back in place
until it clicks in position and close the compartment, using a
screwdriver.
The large parent unit is now ready for battery
operated use.