Connecting / Disconnecting The Belt Clip; Small Parent Unit; Troubleshooting - Philips NZ-SCD450/79 Mode D'emploi

Features
EN

Troubleshooting

Problem
No sound on parent units Volume off or too low.
No connection
between units.
Battery pack of

small parent unit

does not charge.
14

Connecting / disconnecting the belt clip

(small parent unit)
You can carry the small parent in and around your house, giving
you freedom of movement while still monitoring your baby.
Connecting the belt clip
• Insert the little spindle on the rear of the belt clip into the
recess on the rear of the parent unit.
Turn the belt clip to the left until it clicks in position.
Disconnecting the belt clip
• Turn the belt clip to the right (TURN 2) and take it off.
Possible cause
Units out of range.
Units are set to different
channels.
Parent units out of range of
tansmitted signal.
Battery life at an end.
Solution
Turn VOLUME controls (B-9, C-10)
on parent units downwards.
Move parent units closer to
baby unit.
Set channel selection switches
(A-9, B-8, C-8) to the same
position on all three units.
Move parent units closer
to baby unit.
Replace battery pack (C-14).