Philips NZ-SCD450/79 Mode D'emploi page 15

Problem
Interference or poor
reception
LINK lights (B-3, C-9)
flashing red / LINK
alarms beep.
Possible cause
Mobile or cordless phone(s)
too close to baby monitor.
Interference from other
baby monitors in the
neighborhood.
Battery power running low.
Transmitted signal is out of
range; e.g. there are too many
walls and/or ceilings between
baby unit and parent units.
Parent units located too close
to a window and picking up
interfering signals from other
appliances.
Units are out of range.
Interference from another
baby monitor.
Interference from another
FM source.
Troubleshooting
Solution
Move phone(s) away from
baby monitor.
Switch all units to another
channel using the channel
selection switch (A-9, B-8, C-8).
Recharge battery pack (C-14) of
small parent unit in time.
Replace batteries of large parent
unit and / or baby unit.
Move parent units closer
to baby unit.
Move parent units away
from window.
Move units closer together.
Switch to a different channel
(A-9, B-8, C-8).
Remove other FM source.
EN
15