Safety Information; Baby Unit - Philips NZ-SCD450/79 Mode D'emploi

Philips is dedicated to produce caring, reliable products to give parents the reassurance they
need.With this baby monitor you can hear your baby from where ever you are in and around
your house.With sixteen different channels options you will experience minimal interference.
Philips Baby Care, taking care together

Safety information

Please read this user manual carefully before using your baby monitor and keep it for future
reference.This baby monitor is intended as an aid. It is not a substitute for responsible and
proper adult supervision and should not be used as such.
• Make sure the baby unit and adapter cable are always out of reach of the baby
(at least 1 meter / 3 feet away).
• Never place the baby unit inside the baby's bed or playpen.
• Never cover the baby monitor (with a towel, blanket, etc.).
• Never use the baby monitor in moist places or close to water.
• Check if the voltage indicated on the type plate of the adapters (A-4, B-4, C-3) correspond to
the local power voltage before connecting to the AC power supply.
• Do not expose the baby monitor to extreme cold, heat or light (e.g. direct sunlight).
• To prevent electric shock, do not open the inside of the baby unit and parent units
(except for the battery compartment covers)
• The antennas on all three units are fixed; do not try to extend them.

Baby unit

The baby unit can be mains or battery operated.
When batteries are installed, you have an automatic back up in
case of mains failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — — < < + + - A-3) of the baby unit.
2 Connect the AC power adapter (A-4) to a wall outlet.
The baby unit is now ready for mains operated use.
Battery operated use
1 Remove the battery compartment cover (A-10) of the baby
unit, using a coin.
Getting your baby monitor ready
Welcome
EN
7